Moduli

The I/O enclosure offers the installer the flexibility to create their own, customised I/O panel and supports 3x Syncro I/O cards ..

The I/O enclosure offers the installer the flexibility to create their own, customised I/O panel and supports 2x Syncro I/O cards. Space for 3.2Ah batteries..

The I/O enclosure offers the installer the flexibility to create their own, customised I/O panel and supports 2x Syncro I/O cards. Space for 3.2Ah batteries..

Expansion board which can be used to replace a conventional detection panel interfacing circuits directly to a Syncro addressable system, 4x monitored conventional detection zones, max 30 devices per ..

Expansion board with 6 monitored sounder Outputs, Max 1 Amp per output, Full cause and effect available for all outputs, 2 wire RS485 Communication with panel, Panel will support max 32 expansion Boar..

Expansion board with 8 Volt Free Relay Outputs, rated 1 Amp @30V DC, Full cause and effect available for all outputs, 2 wire RS485 Communication with panel, Panel will support max 32 expansion Boards&..

Expansion board with 16 channels, each channel can be individually programmed as an open collector output or opto-isolated input, Full cause and effect available for all inputs/outputs, 2 wire RS485 C..

Loop isolator module with high base, installed as element inside the loop, it is not addressable, there is not need to configure this element..

Master module for connecting conventional detectors and/or manual call points (zone powered)..

Master module for connecting conventional detectors and/or manual call points in an algorithmic-addressable fire detection system..

Output 1 relay supervised, R1 output relay is supervised by a final line resistance of 33kΩ that indicate the state of opened line or short circuit. \n \nR2 output relay operate as a dry contact NO an..

Output 2 relays supervised, in the standby state monitors both external \n \nline by means of a 33k resistance, indicating the state of open line or crossed line..

Output 2 relays supervised, separately activated, independent timing, as well as a combination of sensors that activate them. \n \nThe R1 and R2 outputs are voltage free C/ NC/ NA, for fire doors and ..

Wifi module for Eyehome+ (with APP)..

Module with input to monitor equipment external to the system, 1 alarm / 1 failure..

Module with 8 inputs to monitor equipment external to the system..

Input/output module has 1 relay output fed by external 30V and 1 \n \ntechnical signal input to distinguish the open or closed state of a dry contact, module is protected by 0,9A reset. fuse and the r..

Taktis Network card \n \nPartially isolated network providing RS485 communications for general use...

Syncro Fault Tolerant Network Card \n \nAdded to Syncro AS panels when multiple panels are required to be connected together as a network, Supports a network of 64 Syncro AS panels in fully fault tole..

Syncro AS Loop 2 Extension Card: Apollo  Protocol \n \nUsed to expand a  Apollo protocol single loop Syncro AS to two loops or can be used as a replacement part for Syncro AS 2 loop panels..

Syncro AS Loop 2 Extension Card: Hochiki  Protocol \n \nUsed to expand a Hochiki protocol single loop Syncro AS to two loops or can be used as a replacement part for Syncro AS 2 loop panels..

Dual loop card kit \n \nExpands Taktis addressable loop capacity by 2 loops..

Dual Relay Controller - DIN Enclosure with SCI ..

Dual Sounder Controller - DIN Enclosure with SCI..

Dual Zone Monitor - DIN Enclosure with SCI ..